Vinotemp 2500CD Manual de Serviço

WINE-MATE Cooling Unit Service Manual VINO-1500HZD VINO-2500HZD Vinotemp International Inc. wwwwww..vviinnootteemmpp..ccoomm wwwwww..wwiinn

- 9 -4) Removing the Electronic Controller Figure 2-7

- 10 -6. Remove the thermistor from the mounting clip o

- 11 -1. Unplug the WINEMATE cooling unit or disconnec

- 12 -Note: Any time the sealed system is accessed the

- 13 -3. Servicing and Diagnosis This section ins

- 14 -D. Fan Wires: black shrunk wire from the fan term

- 15 -A. Resistance 1. Unplug WINEMATE cooling unit

- 16 -3) Start Relay A start relay’s function is to e

- 17 -electronic controller will turn on the compressor

- 18 -3. Set the voltmeter to the AC 200 scale. 4. T

- 1 -SAFETY INFORMATION

- 19 -1. The WINEMATE unit needs to be plugged in and

- 20 - Figure 3-5B (5 button controller) III. Troub

- 21 -starting , but temperature rising high 3. Temper

- 22 -too long b. Cellar too large c. Ambient temper

- 23 -condensate c. Evaporator air flow restriction d.

- 24 -4. Customer Support If you still have problems,

- 25 -5. Warranty I. Limited Warranty VI

- 26 -II. Limitation of Implied Warranty VINOTEMP’S SO

- 2 -TABLE OF CONTENTS 1. Introduction…………………………………

- 3 -1. Introduction VINOTEMP assumes no responsibil

- 4 -• Use dry nitrogen to purge the system. • Do not

- 5 -2. Component Information and Access This sectio

- 6 -II. Component Access 1) Removing the Outer Cover

- 7 - Figure 2-3 Figure 2-4

- 8 -3) Removing the Fan Plate 1. Disconnect the powe